Features:
- Initial Release (for updating beta-version timebars)
Download:
TIMEBAR firmware 1.0.0 update app (macOS/Windows)
Before you start:
- Make sure your TIMEBAR has sufficient battery. If your updating computer is a laptop, make sure it has sufficient battery or is connected to mains
- The Tentacle Sync Studio software (macOS) or the Tentacle Setup software (macOS/Windows) should not be running at the same time as the Firmware Update App.
Update procedure:
- Download the firmware update app, install it and open it
- Connect your TIMEBAR via USB cable to the computer and switch it on
- Wait for the update app to connect to your TIMEBAR
- If an update is needed, start the update by pressing the "Start Firmware Update" button
- The updater app will tell you when your TIMEBAR was successfully updated
- To update more TIMEBARs you have to close and start the app again
Note:
Make sure you have the latest iOS/Android Setup App installed.
In the unlikely case that the firmware update fails, your device needs to be restored.
In this case please contact: support@tentaclesync.com